Toyota 4Runner: Rear Door Belt Moulding

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota 4Runner:

Acceleration Sensor Internal Circuit (C1419,C1435)
DESCRIPTION The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system. The yaw rate and acceleration sensor has a built-in acceleration sensor and detects the vehicle condition using 2 circuits (GL1, ...

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY 3. REMOVE FRONT FENDER APRON SEAL RH 4. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH 5. REMOVE NO. 1 OIL COOLER INLET HOSE AND NO ...