Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rear Spoiler / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL REAR NO. 2 SPOILER CLIP

HINT:

Use the same procedure to install the rear No. 2 spoiler clip on the other side.

(a) Attach the 2 claws to install a new rear No. 2 spoiler clip.

2. INSTALL REAR SPOILER SUB-ASSEMBLY

(a) Attach the 3 claws to install the rear spoiler.

(b) Connect the connector.

3. INSTALL REAR NO. 1 SPOILER COVER

(a) Attach the 4 clips to install the rear No. 1 spoiler cover.

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: When installing the rear spoiler protector, heat the rear spoiler surface using a heat light. Standard: Item Temperature ...

Rocker Panel Moulding

Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH ...

Other materials about Toyota 4Runner:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (a) Disconnect the S10 sliding roof drive gear sub-assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure ...

Initialization
INITIALIZATION 1. ZERO POINT CALIBRATION NOTICE: Make sure that the front passenger seat is not occupied before performing the operation. HINT: Perform the zero point calibration and sensitivity check if any of the following conditions apply. ...