Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Side Moulding / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH

(a) Install new 9 clips to the front fender moulding sub-assembly LH.

(b) Attach the 9 clips to install the front fender moulding sub-assembly LH.

(d) w/ Intuitive Parking Assist System:

(1) Install the clip.

(e) Install a new grommet.

2. INSTALL ROCKER PANEL MOULDING COVER LH (w/o Intuitive Parking Assist System)

(a) Attach the 2 clips to install the rocker panel moulding cover LH.

(b) Install the screw.

3. INSTALL ROCKER PANEL MOULDING LH (w/ Intuitive Parking Assist System)

4. INSTALL FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System)

5. INSTALL FRONT FENDER MUDGUARD LH (w/ Intuitive Parking Assist System)

6. INSTALL NO. 3 OUTSIDE MOULDING RETAINER

(a) Attach the claw to install the No. 3 outside moulding retainer.

(b) Install the screws.

7. INSTALL REAR DOOR OUTSIDE MOULDING LH (w/o Intuitive Parking Assist System)

(a) Install new 7 clips to the rear door outside moulding LH.

(b) Attach the 7 clips and 2 claws to install the rear door outside moulding LH.

8. INSTALL REAR DOOR OUTSIDE MOULDING LH (w/ Intuitive Parking Assist System)

(a) Install new 7 clips to the rear door outside moulding LH.

(b) Attach the 7 clips and 2 claws to install the rear door outside moulding LH.

9. INSTALL REAR QUARTER OUTSIDE MOULDING LH

(a) Install new 4 clips to the rear quarter outside moulding LH.

(b) Attach the 4 clips to install the rear quarter outside moulding LH.

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. When installing the pad, heat the moulding su ...

Side Step

Components COMPONENTS ILLUSTRATION ILLUSTRATION Disassembly DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed b ...

Other materials about Toyota 4Runner:

IG Signal Circuit
DESCRIPTION This circuit detects the ignition switch ON or off condition, and sends it to the main body ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspect ...

Unable To Connect To Call Center
DESCRIPTION This may occur when the intensity of the telephone radio frequency was very weak, PRL updates are required or the Safety Connect system has a malfunction, and a DTC is stored. PROCEDURE 1. CHECK COMMUNICATION SERVICE C ...