Toyota 4Runner manuals

Toyota 4Runner: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FOG LIGHT ASSEMBLY LH

(a) Attach the 2 guides.

(b) Install the fog light assembly LH with the 2 screws.

2. INSTALL FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Intuitive Parking Assist System)


3. INSTALL FRONT BUMPER REINFORCEMENT STOPPER RH (w/o Intuitive Parking Assist System, for RH Side)


4. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)

(See page )


5. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)

(See page )


6. ADJUST FOG LIGHT AIMING

(See page )


Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FOG LIGHT BULB ...

Hazard Warning Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH 2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH 3. REMO ...

Other materials about Toyota 4Runner:

Transmitter ID1 Error (C2141/41-C2145/45)
DESCRIPTION The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the air pressure of the tires. The measured values are transmitted to the tire pressure warning antenna and receiver on the body as ...

Adjustment
ADJUSTMENT PROCEDURE 1. STEERING OFF CENTER ADJUSTMENT PROCEDURE HINT: This is the adjustment procedure for when the steering is off center. (a) Check if the steering wheel is off center. (1) Apply masking tape to the top center of the steerin ...

© 2016-2026 | www.to4runner.net

0.0172