Toyota 4Runner: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT BUMPER BAR REINFORCEMENT LH (w/o Intuitive Parking Assist System)
(a) Install the front bumper bar reinforcement LH with the 3 screws.
2. INSTALL FRONT BUMPER BAR REINFORCEMENT LH (w/ Intuitive Parking Assist System)
(a) Install the front bumper bar reinforcement LH with the 2 screws.
3. INSTALL HEADLIGHT ASSEMBLY LH
(a) Connect the 4 connectors and install the headlight assembly LH.
(b) Install the 3 screws and bolt.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
4. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(See page .gif)
)
5. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(See page )
6. INSTALL FRONT FENDER MAIN SEAL LH
7. INSTALL FRONT FENDER MAIN SEAL RH
HINT:
Use the same procedure as for the LH side.
8. INSTALL UPPER RADIATOR SUPPORT SEAL
9. ADJUST HEADLIGHT AIMING
(See page )
10. ADJUST FOG LIGHT AIMING
(See page )
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT TURN SIGNAL LI ...
Other materials about Toyota 4Runner:
Diagnosis System
DIAGNOSIS SYSTEM
1. DIAGNOSIS SYSTEM
(a) Indicator light
(1) During vehicle stabilizer control operation, the KDSS indicator light comes
on when there is a malfunction in the KDSS.
NOTICE:
When the malfunction has been corrected, the KDSS indica ...
High Power Supply Voltage Malfunction (C1417)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU
(housed in the master cylinder solenoid) stores this DTC and the fail-safe function
prohibits ABS/VSC/TRAC operation.
This DTC is stored when the IG1 terminal volt ...
0.0214