Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL TURN SIGNAL FLASHER ASSEMBLY
(a) Install the turn signal flasher assembly with the nut.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(b) Connect the connector.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
.gif)
3. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
4. INSTALL NO. 2 SWITCH HOLE BASE
5. INSTALL COWL SIDE TRIM BOARD LH
6. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
Removal
REMOVAL
PROCEDURE
1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH
2. REMOVE COWL SIDE TRIM BOARD LH
3. REMOVE NO. 2 SWITCH HOLE BASE
4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
5. ...
Mirror (ext)
...
Other materials about Toyota 4Runner:
Vehicle Speed Signal Malfunction (B2282,B2283)
DESCRIPTION
The power management control ECU and the combination meter are connected by a
cable and the CAN communication lines. This DTC is stored when the vehicle speed
signal information from the cable and the vehicle speed signal information from
th ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
0.0084