Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Interior / Heating / Air Conditioning / Air Conditioning Amplifier / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY

(a) Attach the 2 claws to install the air conditioning amplifier assembly.

2. INSTALL ECU INTEGRATION BOX RH

(a) Install the ECU integration box RH with the 2 nuts and bolt.

(b) Attach the clamp and connect the connectors.

NOTICE:

Do not twist the connectors of ECU when connecting them.
Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

5. INSTALL INSTRUMENT PANEL BOX DOOR COVER

6. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

7. INSTALL LOWER INSTRUMENT COVER LH

8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

(a) Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.

10. INSTALL COWL SIDE TRIM BOARD RH

(a) Attach the clip and claw to install the cowl side trim board.

11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

(a) Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.

(b) Install the clip.

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

13. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Other materials about Toyota 4Runner:

Security Horn Circuit
DESCRIPTION When the theft deterrent system is in the alarm sounding state, the main body ECU outputs a signal repeatedly at 0.4 second intervals, causing the security horn assembly to sound WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System ...

Toyota 4Runner: Installation

Components

Removal

Other materials about Toyota 4Runner: