Toyota 4Runner: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
(a) Apply MP grease to a new O-ring.
(b) Install the O-ring to the axle hub.
NOTICE:
Do not damage the O-ring.
(c) Install the disc brake dust cover and axle hub to the steering knuckle with the 4 bolts.
Torque:
80 N·m {816 kgf·cm, 59 ft·lbf}
2. INSTALL FRONT DISC
.gif)
3. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
4. INSTALL FRONT WHEEL
Torque:
for aluminum wheel :
103 N·m {1050 kgf·cm, 76 ft·lbf}
for steel wheel :
112 N·m {1142 kgf·cm, 83 ft·lbf}
5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment (See page
).
6. CHECK SPEED SENSOR SIGNAL
(a) Inspect the speed sensor signal (See page
).
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
PROCEDURE
1. INSTALL PLUG
(a) Using the SST and a hammer, install a new plug.
SST: 09950-60010
09951-00450
SST: 09950-70010
09951-07100
...
Other materials about Toyota 4Runner:
Side Step
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE SIDE ST ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Apply the parking brake and turn the ignition switch on (IG).
(b) Depress the brake pedal and check that the engine starts when the shift lever
is in N or P, but does no ...
0.0064