Toyota 4Runner: Installation

INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

(a) Apply MP grease to a new O-ring.

(b) Install the O-ring to the axle hub.

(c) Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque:

80 N·m {816 kgf·cm, 59 ft·lbf}

2. INSTALL FRONT AXLE SHAFT NUT

(a) Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.

(b) Install the front axle shaft nut.

Torque:

235 N·m {2396 kgf·cm, 173 ft·lbf}

(c) Install the adjusting cap and cotter pin.

3. INSTALL FRONT AXLE HUB GREASE CAP

(a) Install a new axle hub grease cap.

NOTICE:

Make sure the grease cap is securely installed to the axle hub.

4. INSTALL FRONT DISC

5. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

6. BLEED BRAKE LINE

(a) Bleed the brake line (See page ).

7. CHECK FLUID LEVEL IN RESERVOIR

8. CHECK FOR BRAKE FLUID LEAKAGE

9. INSTALL FRONT WHEEL

Torque:

for aluminum wheel :

103 N·m {1050 kgf·cm, 76 ft·lbf}

for steel wheel :

112 N·m {1142 kgf·cm, 83 ft·lbf}

10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment (See page ).

11. CHECK SPEED SENSOR SIGNAL

(a) Inspect the speed sensor signal (See page
).