Toyota 4Runner: Jam Protection Function does not Operate

Toyota 4Runner Service Manual / Vehicle Exterior / Window / Glass / Power Window Control System / Jam Protection Function does not Operate

DESCRIPTION

This problem may occur in all door windows.
The jam protection function operates within a specified range during the manual up or auto up operation.

PROCEDURE

1.	PERFORM INITIALIZATION

(a) Initialize the power window regulator motor (See page ).

(b) Check if the power window auto up/down function operates (See page ).

OK:

Auto up/down function operates.

GO TO OTHER PROBLEM

2.	CHECK JAM PROTECTION FUNCTION OPERATING RANGE

(a) Check if the jam protection function operates for applicable power window.

HINT:

The jam protection function does not operate between the fully closed position of the door glass and the position 4 mm (0.157 in.) below that.

OK:

Jam protection function operates.

END

REPLACE POWER WINDOW REGULATOR MOTOR (APPLICABLE MOTOR)

Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)

DESCRIPTION If any door glass or a power window regulator motor assembly does not operate smoothly, the catch protection function may be triggered automatically, resulting in the auto down operat ...

Power Window Master Switch

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH 2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH 3. REMOVE FRONT DOOR TR ...

Other materials about Toyota 4Runner:

Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION When the front doors are closed, each power window regulator motor can control its power window operation for approximately 43 seconds after the ignition switch is turned from ON to off by receiving operation permission signals ...

Front Airbag Sensor LH Malfunction (B1615/14)
DESCRIPTION The front airbag sensor LH consists of the diagnostic circuit and frontal deceleration sensor, etc. If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated. DTC B16 ...

0.0261