Toyota 4Runner: Manual Shifting Test
MANUAL SHIFTING TEST
1. MANUAL SHIFTING TEST
HINT:
- Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.
- If any abnormalities are found in the following test, the problem is in the transmission itself.
(a) Disconnect the connector of the transmission wire.
HINT:
It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gear positions can then be changed mechanically with the shift lever.
(b) Drive with the transmission wire disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.
|
Shift Lever Position |
Gear Position |
|---|---|
|
P |
P |
|
R |
R |
|
D |
4th |
(c) Connect the connector of the transmission wire.
(d) Clear the DTCs (See page .gif)
).
Hydraulic Test
HYDRAULIC TEST
1. PERFORM HYDRAULIC TEST
(a) Measure the line pressure.
CAUTION:
The line pressure test should always be carried out in pairs. One technician
should observe the conditions of the ...
Initialization
INITIALIZATION
1. RESET MEMORY
NOTICE:
Perform Reset Memory (AT initialization) when replacing the automatic
transmission assembly, valve body assembly or any of the shift solenoid
...
Other materials about Toyota 4Runner:
Driving assist systems
To help enhance driving safety and performance, the following systems
operate automatically in response to various driving situations.
Be aware, however, that these systems are supplementary and should not be
relied upon too heavily when operating the veh ...
Inspection
INSPECTION
PROCEDURE
1. CHECK BRAKE CYLINDER AND PISTON
(a) Check the cylinder bore and piston for rust or scoring.
If necessary, replace the disc brake cylinder assembly.
2. CHECK PAD LINING THICKNESS
(a) Using a ruler, measure the pad lining ...
0.0272