Toyota 4Runner: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Climate control seat system does not operate |
Refreshing seat switch |
|
|
Harness or connector |
- |
|
|
Seat heater LH does not operate |
Refreshing seat switch |
|
|
Seat heater control sub-assembly LH |
|
|
|
Front seat cushion heater assembly LH |
|
|
|
Front seatback heater assembly LH |
|
|
|
Harness or connector |
- |
|
|
Seat heater RH does not operate |
Refreshing seat switch |
|
|
Seat heater control sub-assembly RH |
|
|
|
Front seat cushion heater assembly RH |
|
|
|
Front seatback heater assembly RH |
|
|
|
Harness or connector |
- |
|
|
One or both blowers do not operate (LH) |
Refreshing seat switch |
|
|
Seat cushion climate control blower LH |
- |
|
|
Seatback climate control blower LH |
- |
|
|
Air conditioning amplifier assembly |
|
|
|
Harness or connector |
- |
|
|
One or both blowers do not operate (RH) |
Refreshing seat switch |
|
|
Seat cushion climate control blower RH |
- |
|
|
Seatback climate control blower RH |
- |
|
|
Air conditioning amplifier assembly |
|
|
|
Harness or connector |
- |
.gif)
Operation Check
OPERATION CHECK
1. CHECK SEAT CUSHION CLIMATE CONTROL BLOWER
(a) Turn the engine switch on (IG).
(b) Set the refreshing seat switch blower side to level 3 (maximum).
(c) Check that the fan motor t ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH
(a) Disconnect the b24 seat heater control sub-assembly LH connector.
...
Other materials about Toyota 4Runner:
Unable To Connect To Call Center
DESCRIPTION
This may occur when the intensity of the telephone radio frequency was very weak,
PRL updates are required or the Safety Connect system has a malfunction, and a DTC
is stored.
PROCEDURE
1.
CHECK COMMUNICATION SERVICE C ...
AUTO LSD Indicator Light Remains ON
DESCRIPTION
During normal mode, pressing the VSC OFF switch for a short amount of time changes
vehicle to AUTO LSD mode.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page
).
PR ...
0.0081