Toyota 4Runner: Rear No. 1 Seat Inner Belt Assembly(for 60/40 Split Double-folding Seat Type Lh Side)
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
(a) Install the inner belt with the bolt.
Torque:
42 N·m {428 kgf·cm, 31 ft·lbf}
2. INSTALL REAR SEATBACK ASSEMBLY LH
.gif)
3. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY LH
4. INSTALL REAR SEATBACK COVER
5. INSTALL REAR SEAT HEADREST ASSEMBLY
(a) Install the rear seat headrest assembly (See page
).
(b) Return the seat cushion to its original position.
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SEAT HEADREST ASSEMBLY
|
(a) Pull the rear seat cushion band, release the lock and lift up the back of the seat cushion to rotate it forward. |
|
(b) Remove the rear seat headrest assembly (See page
.gif)
).
2. REMOVE REAR SEATBACK COVER
3. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY LH
4. REMOVE REAR SEATBACK ASSEMBLY LH
5. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
(a) Remove the bolt and inner belt.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
A bolt without a torque specification is shown in the standard bolt cha ...
Rear No. 1 Seat Inner Belt Assembly(for 60/40 Split Double-folding Seat Type
Rh Side)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
(a) Pull the rear seat cushion band, release the lock and lift ...
Other materials about Toyota 4Runner:
Stop Light Switch
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Disconnect the connector from the stop light switch assembly.
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to the "See page" below.
Wireless Door Lock Control System
DTC Code
...
0.0256