Toyota 4Runner: Problem Symptoms Table

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Wireless Door Lock Control System(w/ Smart Key System) / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Wireless Door Lock Control System

Symptom	Suspected Area	See page
Wireless control function and entry function do not operate	Proceed to "All Door Entry Lock / Unlock Functions and Wireless Functions do not Operate"
Wireless control function does not operate but entry function operates	Replace door control transmitter	-
Only answer-back function does not operate	Proceed to "No Answer-Back"
Only automatic lock function does not operate	Proceed to "Door Courtesy Switch Circuit"
	Proceed to "Back Door Courtesy Switch Circuit"
	Main body ECU
Only illuminated entry function does not operate	Lighting system
Only door ajar warning function does not operate	Proceed to "Door Courtesy Switch Circuit"
	Proceed to "Back Door Courtesy Switch Circuit"
	Main body ECU
Only panic alarm function does not operate	Theft deterrent system

Operation Check

OPERATION CHECK 1. NOTICES WHEN CHECKING (a) Wireless door lock/unlock function: The wireless door lock control function operates only when the following conditions are met: The engine sw ...

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU) (See page ). (b) Measure th ...

Other materials about Toyota 4Runner:

Rear Shock Absorber(w/ Reas)
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT NOTICE: Be sure to read the precaution before performing this procedure (See page ). HINT: Use the same procedure for the RH and LH sides. The procedure lis ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (a) Install new 9 clips to the fro ...