Toyota 4Runner: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to the system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Power source mode does not change to on (IG) or on (ACC) |
Refer to "Power Source Mode does not Change to ON (IG and ACC)" |
|
|
Power source mode does not change to on (IG) |
Refer to "Power Source Mode does not Change to ON (IG)" |
|
|
Power source mode does not change to on (ACC) |
Refer to "Power Source Mode does not Change to ON (ACC)" |
|
|
Engine does not start |
Refer to "Engine does not Start" |
|
.gif)
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the push-button start function.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT T ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK POWER MANAGEMENT CONTROL ECU
(a) Disconnect the F80 power management control ECU connector.
(b) Measure the voltage and resistance according to the value(s) in the table ...
Other materials about Toyota 4Runner:
Personal Light(for Front Door)
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
(a) Apply battery voltage to the connector and check the LED illumination.
OK:
Measurement ...
Downhill Assist Control Indicator Light does not Come ON
DESCRIPTION
Even if the downhill assist control switch is pressed, the downhill assist control
indicator light blinks and downhill assist control does not activate under the following
conditions:
The transfer is in H4.
The brake system is malf ...
0.0068