PROBLEM SYMPTOMS TABLE
HINT:
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
When shift lever is in R, rear view monitor image is not displayed (screen is not black) |
Proceed to "Reverse Signal Circuit" |
|
|
Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" |
|
|
|
Navigation receiver assembly |
|
|
|
When shift lever is in R, rear view monitor image is not displayed (screen is black) |
Proceed to "Navigation Receiver Assembly Power Source Circuit" |
|
|
Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" |
|
|
|
Television camera assembly |
|
|
|
Navigation receiver assembly |
|
|
|
When shift lever is not in R, rear view monitor image is displayed |
Proceed to "Reverse Signal Circuit" |
|
|
Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" |
|
|
|
Navigation receiver assembly |
|
|
|
Problem with rear view monitor image (color, distortion of picture) |
Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" |
|
|
Television camera assembly |
|
|
|
Navigation receiver assembly |
|
System Description
Terminals Of EcuEngine Speed Signal Error (Test Mode DTC) (C2194/94)
DESCRIPTION
The tire pressure warning ECU receives an engine speed signal from the ECM. This
DTC is stored upon entering test mode and cleared when an engine speed signal of
1000 rpm is detected for 3 seconds or more. This DTC is stored only in test mode. ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
(e) Check for DTCs.
HINT:
Refer to ...