Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Back Door Belt Moulding / Installation

INSTALLATION

PROCEDURE

1. INSTALL OUTER BACK DOOR GLASS WEATHERSTRIP ASSEMBLY

(a) Attach the 8 claws to install the outer back door glass weatherstrip.

2. INSTALL BACK DOOR GLASS

3. INSTALL BACK DOOR GLASS RUN

4. INSTALL NO. 1 BACK WINDOW WIPER MOTOR BRACKET

5. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY

6. INSTALL REAR WIPER ARM

7. INSTALL REAR SPOILER SUB-ASSEMBLY

8. INSTALL REAR NO. 1 SPOILER COVER

9. INSTALL BACK DOOR OUTSIDE MOULDING LH

10. INSTALL BACK DOOR OUTSIDE MOULDING RH

HINT:

Use the same procedure described for the LH side.

11. INSTALL BACK DOOR SERVICE HOLE COVER LH

12. INSTALL BACK DOOR SERVICE HOLE COVER RH

13. INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER

14. INSTALL MULTIPLEX NETWORK DOOR ECU

15. INSTALL REAR NO. 2 SPEAKER ASSEMBLY

16. INSTALL BACK DOOR TRIM PANEL ASSEMBLY

17. INSTALL ASSIST STRAP ASSEMBLY

18. INSTALL ASSIST STRAP HOLE COVER

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

20. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Back Door Garnish(for Side)

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE MOULDING LH (a) Attach the 5 clips to install the back door outside moulding. 2. INSTA ...

Other materials about Toyota 4Runner:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY (a) Using a dial indicator, check the propeller shaft runout. Maximum runout: 0.3 mm (0.0118 in.) If the shaft runout is more than the maximum, replace the propeller shaft. ...