Toyota 4Runner: Reassembly

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rear Bumper / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL REAR BUMPER SIDE BRACKET LH

(a) Attach the guide.

(b) Install the rear bumper side bracket LH with the 2 screws and clip.

2. INSTALL REAR BUMPER SIDE BRACKET RH

HINT:

Use the same procedure as for the LH side.

3. INSTALL REAR BUMPER EXTENSION (w/o Pintle Hook)

(a) Attach the 4 claws to install the rear bumper extension.

(b) Install the 2 clips and 2 outside moulding retainers.

4. INSTALL REAR BUMPER EXTENSION (w/ Pintle Hook)

(a) Attach the 4 claws to install the rear bumper extension.

(b) Install the 2 clips and 2 outside moulding retainers.

5. INSTALL REAR BUMPER LOWER COVER (w/ Garnish)

(a) Attach the claw to install the rear bumper lower cover.

(b) Install the 14 outside moulding retainers and 2 clips.

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE REAR BUMPER LOWER COVER (w/ Garnish) (a) Remove the 2 clips and 14 outside moulding retainers. (b) Detach the c ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same procedure for all rear propeller shaft universal joint spider bearing. (a) Place matchmarks on the flange yoke and sleeve yoke. Text in Il ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR (a) Turn the ignition switch off. (b) Disconnect the cable from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) bat ...