Toyota 4Runner: Reassembly

Toyota 4Runner Service Manual / Brake / Brake System (other) / Brake Pedal(for Vacuum Brake Booster) / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

(a) Install a new stop light switch mounting adjuster to the brake pedal support assembly.

2. INSTALL BRAKE PEDAL PAD

(a) Install the brake pedal pad.

Adjustment

ADJUSTMENT PROCEDURE 1. CHECK BRAKE PEDAL HEIGHT (a) Check the brake pedal height. Pedal height from Floor panel: 158.8 to 168.8 mm (6.25 to 6.46 in.) Text in Illustration ...

Installation

INSTALLATION PROCEDURE 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Temporarily install the set bolt. (b) Install the brake booster assembly (See page ). (c) Install the brake master cylinder su ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (a) Apply MP grease to a new O-ring. (b) Inst ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE RADIATOR GRILLE 2. REMOVE NO. 2 ENGINE ROOM WIRE (a) Disconnect each connector. (b) Detach the 9 clamps to remove the No. 2 engine room wire. 3. REMOVE NO. 1 ULTRASONIC SENSOR 4. REMOVE ULTRASONIC SENSOR CLIP ...