Toyota 4Runner: Reassembly

Toyota 4Runner Service Manual / Drivetrain / Axle And Differential / Rear Axle Shaft / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

NOTICE:

Do not allow foreign matter, etc. to contact the rear axle hub and bearing assembly.

PROCEDURE

1. INSTALL BRAKE DRUM OIL DEFLECTOR LH

(a) Install a new deflector gasket and deflector to the rear axle shaft.

HINT:

Align the 2 oil drain holes.

Text in Illustration

*1	Oil Drain Holes

(b) Insert 6 new hub bolts.

(d) Install the hub bolts by tightening each nut.

(e) Remove the washer and nut from each hub bolt.

2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH

(a) Install a new rear axle hub and bearing to the parking brake plate.

NOTICE:

Make sure the bearing is securely installed to the parking brake plate.

(b) Using 2 socket wrenches and a press, press in the 4 housing bolts.

3. INSTALL REAR AXLE SHAFT LH

(a) Install a new washer and a new retainer to the axle hub as shown in the illustration.

Text in Illustration

*a	Tapered Surface
*b	Chamfered Surface

NOTICE:

Install the washer with its tapered surface facing downward.
Install the retainer with its chamfered surface facing downward.

(b) Using SST and a press, press in the rear axle shaft.

SST: 09631-12090

SST: 09726-40010

SST: 09951-01100

NOTICE:

Make sure the bearing is securely installed to the rear axle shaft.

4. INSTALL REAR AXLE SHAFT SNAP RING LH

(a) Using snap ring expander, install a new rear axle shaft snap ring.

Inspection

INSPECTION PROCEDURE 1. INSPECT REAR AXLE SHAFT (a) Using a dial indicator, measure the rear axle shaft runout and flange runout. Maximum runout: Shaft runout: 1.50 mm (0.0591 in.) Flange run ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE SHAFT OI ...

Other materials about Toyota 4Runner:

Downhill Assist Control Indicator Light does not Come ON
DESCRIPTION Even if the downhill assist control switch is pressed, the downhill assist control indicator light blinks and downhill assist control does not activate under the following conditions: The transfer is in H4. The brake system is malf ...

System Description
SYSTEM DESCRIPTION 1. NAVIGATION SYSTEM OUTLINE (a) Vehicle position tracking methods It is essential that the navigation system correctly tracks the current vehicle position and displays it on the map. There are 2 methods to track the current vehicle p ...