Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Vehicle Exterior / Lighting (ext) / Fog Light Assembly / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)

(See page )

2. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)

(See page )

3. REMOVE FRONT BUMPER REINFORCEMENT STOPPER RH (w/o Intuitive Parking Assist System, for RH Side)

4. REMOVE FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Intuitive Parking Assist System)

5. REMOVE FOG LIGHT ASSEMBLY LH

(a) Remove the 2 screws.

(b) Detach the 2 guides to remove the fog light assembly LH.

Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FOG LIGHT BULB ...

Adjustment

ADJUSTMENT PROCEDURE 1. VEHICLE PREPARATION FOR FOG LIGHT AIM ADJUSTMENT (a) Prepare the vehicle: Make sure that the vehicle has no damage or deformation around the headlights. Fill ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT PROCEDURE 1. TEMPORARILY INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS (a) Install the lock nut and brake master cylinder push rod clevis to the brake booster assembly. HINT: Tighten the lock nut after adjusting the ...

TS and CG Terminal Circuit
DESCRIPTION The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check. Connecting terminals TS and CG of the DLC3 starts the check. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing ...