Toyota 4Runner: Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page .gif)
).
2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
(a) Remove the instrument panel sub-assembly (See page
).
3. REMOVE NO. 1 HEATER TO REGISTER DUCT
4. REMOVE NO. 2 HEATER TO REGISTER DUCT
5. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
6. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
7. REMOVE NO. 3 HEATER TO REGISTER DUCT
8. REMOVE DEFROSTER NOZZLE ASSEMBLY
9. REMOVE NAVIGATION ANTENNA ASSEMBLY
|
(a) Detach the clamp. |
|
(b) Remove the 2 screws and antenna.
Components
COMPONENTS
ILLUSTRATION
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT NAVIGATION ANTENNA ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester C ...
Other materials about Toyota 4Runner:
Listing the registered portable players
Select “List Audio Players” using a voice command or
. The list of registered portable
players will be read aloud.
When listing is complete, the system returns to “BT Audio Setup”.
Pressing the talk switch while the name of a portable player is be ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
The procedure listed below is for the RH side.
PROCEDURE
1. INSTALL FRONT SEAT ASSEMBLY
(a) Place the front seat assembly in the ...
0.0243