Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Drivetrain / Vf2a Transfer / 4wd / Awd / Transfer Assembly / Removal

REMOVAL

PROCEDURE

1. DRAIN TRANSFER OIL

2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

(a) Remove the automatic transmission (See page ).

3. REMOVE TRANSFER ASSEMBLY

(a) Remove the 8 bolts.

(b) Remove the transfer from the transmission.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE TRANSFER INDICATOR SWITCH (4WD POSITION) 2. REMOVE TRANSFER INDICATOR SWITCH (L4 POSITION) 3. REMOVE TRANSFER INDICATOR SWITCH (NEUTRAL POSITION) 4. REMOV ...

Other materials about Toyota 4Runner:

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. CHECK STOP LIGHT CONTROL RELAY (a) Remove the stop light control relay from the engine room relay block. (b) Measure the resistance according to the value(s) in the table below. Stan ...

Installation
INSTALLATION PROCEDURE 1. INSTALL DOOR CONTROL RECEIVER (a) Install the door control receiver with the bolt. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} (b) Connect the connector. 2. INSTALL D ...