Toyota 4Runner: Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

CAUTION / NOTICE / HINT

NOTICE:

Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.

PROCEDURE

1.	CHECK SATELLITE RADIO

(a) Check radio condition.

Result	Proceed to
Broadcast cannot be selected	A
Broadcast can be selected, but selection can not be memorized	B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

2.	CHECK SATELLITE RADIO

(a) Check the number of preset channels.

OK:

36 channels have already been preset.

END (ONLY 36 CHANNELS CAN BE PRESET)

3.	CHECK BATTERY

(a) Check if the battery was replaced.

OK:

Battery was not replaced.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

4.	ADD PRESET CHANNEL INTO MEMORY AGAIN

(a) Check if the preset channels that have been cleared can be added into memory again.

OK:

Preset channels can be added into memory.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Satellite Radio Broadcast cannot be Received

CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it w ...

Traffic Information is not Displayed

CAUTION / NOTICE / HINT NOTICE: Traffic information requires payment. An "XM Nav Traffic" contract must be made between the satellite radio company and the user. If the contrac ...

Other materials about Toyota 4Runner:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Wireless Door Lock Control System DTC Code ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FOG LIGHT COVER LH (a) Attach the 5 claws to install the fog light cover LH. (b) Install the outside moulding retainer. 2. INSTALL FOG LIGHT COVER RH HINT: Use the same procedure as for the LH side. 3. INSTALL FOG LIGHT ...