DESCRIPTION
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B2341 |
There is a sensor (motor) failure. |
Sliding roof drive gear sub-assembly (Sliding roof motor) |
|
B2344 |
There is a position failure. |
Sliding roof drive gear sub-assembly (Sliding roof ECU) |
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Clear the DTCs (See page
).
(b) Check for DTCs (See page
).
|
Result |
Proceed to |
|---|---|
|
DTC B2341 or B2344 is output |
A |
|
DTC B2343 is output |
B |
|
DTC is not output |
C |
| A | |
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
| B | |
GO TO B2343 |
| C | |
USE SIMULATION METHOD TO CHECK |
Data List / Active Test
Diagnostic Trouble Code ChartAdjusting the position of and opening and closing the air outlets
Front center outlets
1. Direct air flow to the left or right, up or down.
2. Turn the knob to open or close the vent.
Front side outlets
1. Direct air flow to the left or right, up or down.
2. Turn the knob to open or close the vent.
Rear outlets
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL GENERATOR ASSEMBLY
(a) Install the generator bracket to the generator with the bolt.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
(b) Install the generator with the 2 bolts.
Torque:
43 N·m {438 kgf·cm, 32 ft·lbf}
(c ...