DESCRIPTION
This DTC is stored when a malfunction occurs in the stereo component amplifier assembly.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B15A3 |
When one of the conditions below is met:
|
Stereo component amplifier assembly |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check if the same DTC are output again.
OK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
| NG | |
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY |
AV Signal Stoppage (Low Battery Voltage) (B158F)
XM Tuner Malfunction (B15BA)Speed Signal Circuit
DESCRIPTION
The vehicle speed signal consists of pulses sent to the side auto step controller
ECU assembly from the main body ECU (multiplex network body ECU).
WIRING DIAGRAM
PROCEDURE
1.
INSPECT MAIN BODY ECU (MULTIPLEX NETWORK ...
Dtc Check / Clear
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa,
all DTCs and freeze frame data recorded in normal mode are cleared. Before changing
modes, always check and make a note of DTCs and freeze frame ...