Toyota 4Runner: ACC Signal Circuit

Toyota 4Runner Service Manual / Vehicle Interior / Lighting (int) / Lighting System / ACC Signal Circuit

DESCRIPTION

This circuit detects the ignition switch ACC or off condition, and sends it to the main body ECU.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.	READ VALUE USING TECHSTREAM (IGNITION SWITCH)

(a) Using the Techstream, read the Data List (See page ).

Main Body

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
ACC SW	Ignition switch ACC signal / ON or OFF	ON: Ignition switch ACC OFF: Ignition switch off	-

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

ACC SW

Ignition switch ACC signal / ON or OFF

ON: Ignition switch ACC

OFF: Ignition switch off

OK:

Normal conditions listed above are displayed.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

2.	CHECK HARNESS AND CONNECTOR (BATTERY - MAIN BODY ECU)

(a) Remove the main body ECU (See page ).

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Switch Condition	Specified Condition
A-29 (ACC) - Body ground	Ignition switch ACC	11 to 14 V

Text in Illustration

*a	Front view of wire harness connector (to Main Body ECU)

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

REPAIR OR REPLACE HARNESS OR CONNECTOR

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

IG Signal Circuit

DESCRIPTION This circuit detects the ignition switch ON or off condition, and sends it to the main body ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits rela ...

Other materials about Toyota 4Runner:

Rear Power Window LH does not Operate with Rear Power Window Switch LH
DESCRIPTION If the manual up/down function does not operate, there may be a malfunction in the rear power window regulator switch, rear power window regulator motor, harness or connector. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after d ...