Toyota 4Runner manuals

Toyota 4Runner: Antenna Coil Open / Short (B2784)

DESCRIPTION

The antenna coil receives key code signals from the transponder chip in the key grip. The coil is built into the transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key ECU assembly.

This DTC is stored when there is an open or short in the antenna coil.

DTC Code

DTC Detection Condition

Trouble Area

B2784

The antenna coil is open/shorted.

Transponder key amplifier

PROCEDURE

1.

CLEAR DTC

(a) Clear the DTCs (See page ).



NEXT

2.

CHECK FOR DTC

(a) Check for DTCs (See page ).


OK:

DTC B2784 is not output.


OK

USE SIMULATION METHOD TO CHECK


NG

REPLACE TRANSPONDER KEY AMPLIFIER

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" bel ...

Transponder Chip Malfunction (B2793-B2795)
DESCRIPTION DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration c ...

Other materials about Toyota 4Runner:

Unlock Warning Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE LOWER STEERING COLUMN COVER 2. REMOVE UPPER STEERING COLUMN COVER 3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY 4. REMOVE UNLOCK WARNING SWITCH ASSEMBLY (a) ...

ECU Power Source Circuit
DESCRIPTION This is the power source for the tire pressure warning ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down ...

© 2016-2026 | www.to4runner.net

0.0265