Toyota 4Runner: Transponder Chip Malfunction (B2793-B2795)

Toyota 4Runner Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Engine Immobiliser System(w/o Smart Key System) / Transponder Chip Malfunction (B2793-B2795)

DESCRIPTION

DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.
DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.
DTC B2795 is stored when a key with a key code that is not registered in the ECU is inserted into the ignition key cylinder.

DTC Code	DTC Detection Condition	Trouble Area
B2793	A transponder chip malfunction.	Key
B2794	A key with an incomplete key code is inserted into the ignition key cylinder.
B2795	A key with an unregistered key code is inserted into the ignition key cylinder.

CAUTION / NOTICE / HINT

NOTICE:

When the key is replaced, refer to Registration (See page ).

PROCEDURE

1.	REREGISTER KEY

(a) Clear the DTCs (See page ).

(b) Reregister the key code with the transponder key ECU assembly.

OK:

Engine starts.

END

REPLACE KEY

Antenna Coil Open / Short (B2784)

DESCRIPTION The antenna coil receives key code signals from the transponder chip in the key grip. The coil is built into the transponder key amplifier, which amplifies the key code signals and ou ...

Communication Malfunction No. 1 (B2797)

DESCRIPTION This DTC is stored when a communication error occurs between the transponder key amplifier and transponder key ECU assembly. Some possible reasons for the communication error are: 1) ...

Other materials about Toyota 4Runner:

Accessory meter light control
The daytime brightness of the accessory meter can be adjusted. Turn the headlight switch off. Press and hold the “MODE/ ” button. Press the “MODE/ ” or “SET/ ” button. Vehicles without Multi-terrain Select Vehicles with Multi-terrain S ...

Removal
REMOVAL PROCEDURE 1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A) 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 4. REMOVE SEAT HEATER SWITCH (a) Disconnect the 2 connectors. ...