Toyota 4Runner: Engine Immobiliser System(w/o Smart Key System)
Toyota 4Runner Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Engine Immobiliser System(w/o Smart Key System)
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Registration
- System Description
- Dtc Check / Clear
- Problem Symptoms Table
- Push Switch / Key Unlock Warning Switch Malfunction (B2780)
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Antenna Coil Open / Short (B2784)
- Transponder Chip Malfunction (B2793-B2795)
- Communication Malfunction No. 1 (B2797)
- Engine Immobiliser System Malfunction (B2799)
- Theft Deterrent System Presence Detection (B279C)
- No Communication in Immobiliser System (B2796,B2798)
- Security Indicator Light Circuit
- ECU Power Source Circuit
Security Indicator Light Circuit
DESCRIPTION
When the engine immobiliser system is set, the security indicator flashes
continuously, but does not illuminate if the engine immobiliser system is
not set.
WIRING D ...
Parts Location
PARTS LOCATION
ILLUSTRATION
...
Other materials about Toyota 4Runner:
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the window frame moulding, heat the vehicle body and window
frame moulding using a heat li ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
© 2016-2026 | www.to4runner.net
0.0251
0.0251