Toyota 4Runner: Crawl Indicator Light Remains ON
DESCRIPTION
Refer to Crawl Indicator Light does not Come ON (See page
.gif)
).
WIRING DIAGRAM
Refer to Crawl Indicator Light does not Come ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page
).
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (CRAWL CONTROL LIGHT) |
| A | .gif) |
REPLACE MASTER CYLINDER SOLENOID |
|
.gif)
|
2. |
READ VALUE USING TECHSTREAM (CRAWL CONTROL MAIN SWITCH) |
| OK | |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
| NG | |
REPLACE DRIVE MONITOR SWITCH |
ABS Warning Light does not Come ON
DESCRIPTION
Refer to ABS Warning Light Remains ON (See page
).
WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cyl ...
Crawl Indicator Light does not Come ON
DESCRIPTION
If any of the following conditions are met, the crawl indicator light blinks
and crawl control is stopped.
Crawl control is operated when the vehicle stability control system
...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
(a) Align the matchmarks on the yoke and differential flange.
(b) Install the propeller shaft assembly with the 4 washers, 4 bolts and 4 nuts.
Torque:
88 N·m {899 kgf·cm, 65 ft·lbf}
(c ...
Inside rear view mirror
Glare from the headlights of vehicles behind can be reduced by using the
following functions:
Manual anti-glare inside rear view mirror
1. Normal position
2. Anti-glare position
Auto anti-glare inside rear view mirror
In automatic mode, sensors are u ...
0.0067