PROBLEM SYMPTOMS TABLE
HINT:
Symptom |
Suspected Area |
See page |
---|---|---|
Wiper and washer systems do not operate at all |
Windshield wiper switch assembly |
|
Harness or connector |
- |
|
Front wiper system does not operate |
Windshield wiper motor assembly |
|
Windshield wiper switch assembly |
|
|
Harness or connector |
- |
|
Front washer system does not operate |
Windshield washer motor and pump assembly |
|
Windshield wiper switch assembly |
|
|
Harness or connector |
- |
|
Front wipers do not operate when front washer switch is on |
Windshield wiper motor assembly |
|
Windshield wiper switch assembly |
|
|
Harness or connector |
- |
|
When front wiper switch is off, wiper blades do not park or park in wrong position |
Front wiper arm installation position |
|
Windshield wiper motor assembly |
|
Symptom |
Suspected Area |
See page |
---|---|---|
Rear wiper and washer system does not operate |
Windshield wiper switch assembly |
|
Harness or connector |
- |
|
Rear wiper system does not operate |
Proceed to "Rear Wiper does not Operate" |
|
Rear washer system does not operate |
Proceed to "Rear Washer does not Operate" |
|
Rear wiper arm does not return to its original position when wiper switch is turned off |
Rear wiper motor assembly |
|
Harness or connector |
- |
Symptom |
Suspected Area |
See page |
---|---|---|
Washer fluid level warning system does not operate* |
Proceed to "Washer Fluid Level Warning Switch Circuit" |
|
Combination meter assembly |
|
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, black out tape and outside
stripe, heat the vehicle body ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
2. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System ...