DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / SRS Airbag / Data List.
(f) According to the display on the Techstream, read the Data List.
SRS Airbag
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|
Passenger Classification |
Passenger Classification/ NG: Data is not determined OFF: Vacant Child: Child (less than 36 kg (79.37 lb)) is seated AF05: Adult (36 to 54 kg (79.37 to 119.05 lb)) is seated AM50: Adult (more than 54 kg (119.05 lb)) is seated Fail: Failure is detected |
OFF/Child/AF05/AM50 |
- |
Left Side Buckle SW |
Buckle Switch LH/ Unset: Seat belt is not fastened Set: Seat belt is fastened NG: Data is not determined |
Unset/Set |
- |
Right Side Buckle SW |
Buckle Switch RH/ Unset: Seat belt is not fastened Set: Seat belt is fastened NG: Data is not determined |
Unset/Set |
- |
Display Type Information |
Display Type Information/ LR: Display is indicated by LH/RH DP: Display is indicated by Driver/Passenger |
LR |
- |
Number of Past DTC |
Number of Past DTCs/ Min.: 0, Max.: 255 |
0 |
- |
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE TRANSFER INDICATOR SWITCH (4WD POSITION)
2. REMOVE TRANSFER INDICATOR SWITCH (L4 POSITION)
3. REMOVE TRANSFER INDICATOR SWITCH (NEUTRAL POSITION)
4. REMOVE TRANSFER CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY
(a) Re ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System)
3. REMOVE ROCKER PANEL MOULDING COVER LH (w/o Intuitive Parking Assist System)
4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH (w/o Intu ...