Toyota 4Runner: Diagnosis System
DIAGNOSIS SYSTEM
1. DIAGNOSIS SYSTEM
(a) Indicator light
(1) During vehicle stabilizer control operation, the KDSS indicator light comes on when there is a malfunction in the KDSS.
NOTICE:
- When the malfunction has been corrected, the KDSS indicator light goes off.
- There are some malfunctions which do not cause the KDSS indicator light
to come on (See page
.gif)
for the items that
cause the KDSS indicator light to come on).
(b) DTCs
(1) DTCs are stored in the stabilizer control ECU and output by using SST check
wire or the Techstream (See page ).
SST: 09843-18040
Terminals Of Ecu
TERMINALS OF ECU
Text in Illustration
*a
Component with harness connected
(Stabilizer Control ECU)
-
-
Terminal No.
(Symbol)
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK/CLEAR DTC (USING TECHSTREAM)
(a) Check DTC:
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the follo ...
Other materials about Toyota 4Runner:
Engine compartment
1. Washer fluid tank
2. Power steering fluid reservoir
3. Engine oil level dipstick
4. Engine coolant reservoir
5. Engine oil filler cap
6. Brake fluid reservoir
7. Fuse box
8. Battery
9. Condenser 10. Radiator
Engine compartment cover
Remo ...
Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK STOP LIGHT CONTROL RELAY
(a) Remove the stop light control relay from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table below.
Stan ...
0.0112