Toyota 4Runner: Kinetic Dynamic Suspension System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Power Supply Voltage Malfunction (C1882/82)
- Speed Sensor Circuit Malfunction (C1883/83)
- KDSS ECU Malfunction (C1881/81)
- Lost Communication with ECM/PCM "A" (U0100/71,U0122/71,U0124/71,U0126/71)
- Low Pressure Malfunction in Upside of KDSS System (C1851/51,C1853/53)
- Pressure Sensor Malfunction / Upside (C1812/12)
- Accumulator Solenoid Malfunction / Upside (C1831/31,C1832/32)
- Steering Angle Sensor Circuit Malfunction (C1884/84)
- Acceleration Sensor Circuit Malfunction (C1887/87)
- Zero Point Calibration of Acceleration Sensor Undone (C1879/79)
Disposal
DISPOSAL
PROCEDURE
1. DISPOSE OF CENTER CONTROL ABSORBER ASSEMBLY LH
(a) Using a drill, make a hole in the cylinder as shown in the illustration
to discharge the gas inside.
...
Precaution
PRECAUTION
1. KINETIC DYNAMIC SUSPENSION SYSTEM
CAUTION:
Be sure to check the pipe connections and whether or not any hydraulic
circuit parts are damaged before performing work, as the ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
Be sure to read the precaution before performing this procedure (See page
).
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without ...
Relay(for Magnet Clutch Control)
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. REMOVE MAGNET CLUTCH RELAY
(a) Remove the magnet clutch relay from the engine room relay block.
Text in Illustration
*1
Magnet Clutch Relay
...
© 2016-2026 | www.to4runner.net
0.0086
0.0086