Toyota 4Runner: Diagnosis System

Toyota 4Runner Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System / Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Lighting system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and to repair.

2. CHECK DLC3

(a) Check the DLC3 (See page ).

3. INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (See page ). (b) Measure the resistance and voltage accor ...

Dtc Check / Clear

DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired sy ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 2 SEAT ASSEMBLY (a) Remove the rear No. 2 seat assembly (See page ). 2. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board) 3. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board) 4. REMOVE NO. 2 LUG ...

Rear Power Window LH does not Operate with Rear Power Window Switch LH
DESCRIPTION If the manual up/down function does not operate, there may be a malfunction in the rear power window regulator switch, rear power window regulator motor, harness or connector. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE ...