Toyota 4Runner: Lighting System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Light Sensor Circuit Malfunction (B1244)
- Headlight Dimmer Switch Circuit
- Headlight Relay Circuit
- Headlight (HI-BEAM) Circuit
- Front Fog Light Circuit
- Taillight Relay Circuit
License Plate Light Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE OUTSIDE BACK DOOR GARNISH
(a) Remove the outside back door garnish (See page
).
2. REMOVE LICENSE PLATE LIGHT ASS ...
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are ...
Other materials about Toyota 4Runner:
Four-wheel drive system (full-time 4WD models)
Use the four-wheel drive control switch to select the following transfer
modes:
1. H4F (high speed position)
Use this for normal driving on dry hard-surfaced roads. This position gives
greater economy, quietest ride and least wear.
2. H4L (high speed ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
© 2016-2026 | www.to4runner.net
0.0272
0.0272