Toyota 4Runner: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Tire pressure warning system|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
C2111/11 |
Transmitter ID1 Operation Stop |
|
|
C2112/12 |
Transmitter ID2 Operation Stop |
|
|
C2113/13 |
Transmitter ID3 Operation Stop |
|
|
C2114/14 |
Transmitter ID4 Operation Stop |
|
|
C2115/15* |
Transmitter ID5 Operation Stop |
|
|
C2121/21 |
No Signal from Transmitter ID1 in Main Mode |
|
|
C2122/22 |
No Signal from Transmitter ID2 in Main Mode |
|
|
C2123/23 |
No Signal from Transmitter ID3 in Main Mode |
|
|
C2124/24 |
No Signal from Transmitter ID4 in Main Mode |
|
|
C2125/25* |
No Signal from Transmitter ID5 in Main Mode |
|
|
C2126/26 |
Transmitter ID not Received in Main Mode |
|
|
C2141/41 |
Transmitter ID1 Error |
|
|
C2142/42 |
Transmitter ID2 Error |
|
|
C2143/43 |
Transmitter ID3 Error |
|
|
C2144/44 |
Transmitter ID4 Error |
|
|
C2145/45* |
Transmitter ID5 Error |
|
|
C2165/65 |
Abnormal Temperature Inside ID1 Tire |
|
|
C2166/66 |
Abnormal Temperature Inside ID2 Tire |
|
|
C2167/67 |
Abnormal Temperature Inside ID3 Tire |
|
|
C2168/68 |
Abnormal Temperature Inside ID4 Tire |
|
|
C2169/69* |
Abnormal Temperature Inside ID5 Tire |
|
|
C2171/71 |
Transmitter ID not Registered |
|
|
C2173/73 |
Vehicle Speed or Engine Speed Signal Malfunction |
|
|
C2176/76 |
Receiver Error |
|
|
C2181/81 |
Transmitter ID1 not Received (Test Mode DTC) |
|
|
C2182/82 |
Transmitter ID2 not Received (Test Mode DTC) |
|
|
C2183/83 |
Transmitter ID3 not Received (Test Mode DTC) |
|
|
C2184/84 |
Transmitter ID4 not Received (Test Mode DTC) |
|
|
C2185/85* |
Transmitter ID5 not Received (Test Mode DTC) |
|
|
C2191/91 |
Vehicle Speed Signal Error (Test Mode DTC) |
|
|
C2194/94 |
Engine Speed Signal Error (Test Mode DTC) |
|
.gif)
- *: w/ Spare Tire Pressure Warning Valve and Transmitter
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC (USING TECHSTREAM)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) En ...
Receiver Error (C2176/76)
DESCRIPTION
The signals are transmitted to the tire pressure warning antenna and receiver
on the body as radio waves and then sent to the tire pressure warning ECU.
DTC Code
...
Other materials about Toyota 4Runner:
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the c ...
Lumbar Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT LUMBAR SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch ...
0.0265