Toyota 4Runner: Tire Pressure Warning System
Toyota 4Runner Service Manual / Suspension / Tire Pressure Monitoring / Tire Pressure Warning System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Registration
- Test Mode Procedure
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Data List / Active Test
- Dtc Check / Clear
- Diagnostic Trouble Code Chart
- Receiver Error (C2176/76)
- Vehicle Speed or Engine Speed Signal Malfunction (C2173/73)
- Transmitter ID not Received in Main Mode (C2126/26)
- Transmitter ID not Registered (C2171/71)
- Engine Speed Signal Error (Test Mode DTC) (C2194/94)
- No Signal from Transmitter ID1 in Main Mode (C2121/21-C2125/25,C2181/81-C2185/85)
- Abnormal Temperature Inside ID1 Tire (C2165/65-C2169/69)
- Transmitter ID1 Error (C2141/41-C2145/45)
- Transmitter ID1 Operation Stop (C2111/11-C2115/15)
- Vehicle Speed Signal Error (Test Mode DTC) (C2191/91)
- Tire Pressure Warning Light Circuit
- ECU Power Source Circuit
- TC and CG Terminal Circuit
Tire Pressure Warning Receiver(w/ Antenna)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
(a) Remove the roof headlining assembly (See page
).
2. REMOVE TIRE PRESSURE WARNING ANT ...
Precaution
PRECAUTION
1. TIRE PRESSURE WARNING ECU EXPRESSIONS
(a) The tire pressure monitor receiver assembly is referred to as the tire pressure
warning ECU in this section.
2. TIRE PRESSURE WARNING SYSTE ...
Other materials about Toyota 4Runner:
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Line
Center airbag sensor assembly
Main body ECU (multiplex network body ECU)
Front seat inner belt LH buckle swit ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL WIPER MOTOR WIRE
(a) Attach the claw to install the wiper motor wire.
2. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Using a T30 "TORX" socket, install the wiper motor with the 2 bolts.
Torque:
7.5 N·m {76 k ...
© 2016-2026 | www.to4runner.net
0.026
0.026