Toyota 4Runner: Disassembly

Toyota 4Runner Service Manual / Brake / Brake System (other) / Brake Master Cylinder / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE BRAKE FLUID INFORMATION LABEL

2. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

(a) Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.

3. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER

(a) Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly.

4. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

(a) Using a pin punch and hammer, remove the pin from the brake master cylinder reservoir.

5. REMOVE MASTER CYLINDER RESERVOIR GROMMET

(a) Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Removal

REMOVAL CAUTION / NOTICE / HINT NOTICE: Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster. PROCEDURE 1. DRAIN BRAKE FLUID NOTICE ...

Other materials about Toyota 4Runner:

Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
DESCRIPTION The front passenger side squib circuit consists of the center airbag sensor and instrument panel passenger airbag. The circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected ...

Four-wheel drive system (part-time 4WD models)
Use the front-wheel drive control lever or switch to select the following transfer modes: Type A The four-wheel drive indicator comes on when H4, N or L4 mode is selected. 1. H2 (high speed position, two-wheel drive) Use this for normal driving on dry ...