Toyota 4Runner: Disposal

Toyota 4Runner Service Manual / Suspension / Suspension Control / Center Control Absorber(w/ Reas) / Disposal

DISPOSAL

PROCEDURE

1. DISPOSE OF CENTER CONTROL ABSORBER ASSEMBLY LH

(a) Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.

(b) Remove the flare nut.

Installation

INSTALLATION PROCEDURE 1. INSTALL CENTER CONTROL ABSORBER BRACKET LH (a) Install the center control absorber bracket with the 2 bolts. Torque: 29 N·m {296 kgf·cm, 21 ft·lbf} 2. INSTALL CENTE ...

Kinetic Dynamic Suspension System

...

Other materials about Toyota 4Runner:

Back Door Garnish(for Side)
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE MOULDING LH (a) Attach the 5 clips to install the back door outside moulding. 2. INSTALL BACK DOOR OUTSIDE MOULDING RH HINT: Use the same proced ...

Clearance Warning Buzzer
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (a) Remove the instrument panel sub-assembly (See page ). 2. REMOVE NO. 1 CLEARANCE WARNING BUZZER (a) Disconnect the connector. (b) Detach ...