Toyota 4Runner: Front Differential Side Gear Shaft Oil Seal(for 4wd)

Toyota 4Runner Service Manual / Drivetrain / Axle And Differential / Front Differential Side Gear Shaft Oil Seal(for 4wd)

Components

COMPONENTS

ILLUSTRATION

Replacement

REPLACEMENT

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

(a) Remove the front drive shaft assembly LH (See page ).

2. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL

(a) Using SST, tap out the 2 oil seals.

SST: 09308-10010

4. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL

(a) Apply MP grease to 2 new oil seals.

(b) Using SST and a hammer, tap in the 2 oil seals.

SST: 09550-00032

SST: 09950-70010

09951-07100

Standard Oil Seal Depth:

Item	Specified Condition
LH side	-0.45 to 0.45 mm (-0.018 to 0.018 in.)
RH side	4.8 to 5.8 mm (0.189 to 0.229 in.)

Text in Illustration

*1	Differential
*2	Seal
*a	LH side
*b	RH side

NOTICE:

Make sure the LH and RH oil seals are installed in the proper locations.

5. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

(a) Install the front drive shaft assembly LH (See page ).

6. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

Front Differential Carrier Oil Seal(for 4wd)

Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY (a) Remove the front differential carrier assembly (See page ). 2. RE ...

Rear Axle Hub Bolt

Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the ...

Other materials about Toyota 4Runner:

Drive Shaft System
Problem Symptoms Table PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. ...

Inspection
INSPECTION PROCEDURE 1. INSPECT BRAKE BOOSTER PUMP ASSEMBLY (a) Apply battery voltage to the brake booster pump cables, and check the operation of the pump motor. OK:: Measurement Condition Specified C ...