Toyota 4Runner: How To Proceed With Troubleshooting

Toyota 4Runner Service Manual / Power Source / Network / Networking / Lin Communication System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use these procedures to troubleshoot the LIN communication system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

3.	INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Using the Techstream, inspect the CAN communication function to make sure that there are no malfunctions in the communication system (See page ).

Result	Proceed to
No DTCs are output	A
DTCs are output	B

GO TO CAN COMMUNICATION SYSTEM

4.	INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

(a) Using the Techstream, inspect the LIN communication function to make sure that there are no malfunctions in the communication system (See page ).

Result	Proceed to
No DTCs are output	A
DTCs are output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

5.	PROBLEM SYMPTOMS TABLE

(a) Refer to the Problem Symptoms Table (See page ).

Result	Proceed to
Fault is not listed in problem symptoms table	A
Fault is listed in problem symptoms table	B

GO TO STEP 7

6.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List/Active Test (See page ).

(b) Terminals of ECU (See page
).

7.	ADJUST, REPAIR OR REPLACE

END

System Description

SYSTEM DESCRIPTION 1. LIN COMMUNICATION SYSTEM DESCRIPTION The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed t ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE SHIFT LEVER CAP 2. REMOVE POSITION INDICATOR HOUSING ASSEMBLY (a) Detach the 4 claws and remove the floor shift position indicator housing. 3. REMOVE INDICATOR LIGHT ...

Installation
INSTALLATION PROCEDURE 1. INSTALL VOLTAGE INVERTER ASSEMBLY (a) Install the voltage inverter with the 3 bolts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} (b) Connect the 2 connectors. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH 3. INSTALL FRONT DECK ...