Toyota 4Runner: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
.gif)
|
2. |
CUSTOMER PROBLEM ANALYSIS |
(a) Confirm problem symptoms (See page .gif)
).
|
|
3. |
INSPECT BATTERY VOLTAGE* |
(a) Measure the voltage of the battery.
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
|
4. |
CHECK DTC* |
(a) Check and record DTCs.
|
|
5. |
CLEAR DTC* |
(a) Clear the DTCs.
|
|
6. |
PROBLEM SYMPTOM CONFIRMATION |
|
Result |
Proceed to |
|---|---|
|
Symptom does not occur |
A |
|
Symptom occurs |
B |
| B | .gif) |
GO TO STEP 8 |
|
|
7. |
SYMPTOM SIMULATION |
(a) Perform symptom simulation (See page ).
|
|
8. |
CHECK CAN COMMUNICATION SYSTEM* |
(a) Check for DTCs (See page ).
|
Result |
Proceed to |
|---|---|
|
CAN communication system DTC is not output |
A |
|
CAN communication system DTC is output |
B |
HINT:
- If any CAN communication system DTCs are output, perform troubleshooting
for the CAN communication system first (See page
).
- If communication with the power steering ECU assembly cannot be established through the Techstream, inspect terminals CANH and CANL of the DLC3 and power steering ECU assembly, and the IG circuit of the power steering ECU assembly.
| B | |
PROCEED TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
|
|
9. |
CHECK FOR DTC* |
(a) Check for DTCs (See page ).
HINT:
Refer to Diagnostic Trouble Code Chart when any DTCs are output (See page
).
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
DTC is output |
B |
| B | |
GO TO STEP 11 |
|
|
10. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
|
|
11. |
CIRCUIT INSPECTION |
|
|
12. |
IDENTIFICATION OF PROBLEM |
|
|
13. |
REPAIR OR REPLACE |
|
|
14. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
SYSTEM DIAGRAM
...
System Description
SYSTEM DESCRIPTION
1. DESCRIPTION
(a) In the Variable Flow Control (VFC) power steering system, the power steering
ECU assembly receives the steering angle signal, steering zero point memory, the ...
Other materials about Toyota 4Runner:
Vehicle Lift And Support Locations
VEHICLE LIFT AND SUPPORT LOCATIONS
1. NOTICE ABOUT VEHICLE CONDITION WHEN RAISING VEHICLE
(a) The vehicle must be unloaded before jacking up or raising the vehicle. Never
jack up or raise a heavily loaded vehicle.
(b) When removing any heavy components li ...
Green And Red Indicators Blink Simultaneously
DESCRIPTION
After the ignition switch is turned to ON, the DCM (Telematics Transceiver) will
enter a self check mode. The manual (SOS) switch red indicator will illuminate for
2 seconds and turn off followed by the manual (SOS) switch green indicator illu ...
0.007