Toyota 4Runner manuals

Toyota 4Runner: How To Proceed With Troubleshooting

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Key Reminder Warning System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use the following procedures to troubleshoot the key reminder warning system.
  • *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


NEXT

3.

CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally (See page ).


Result

Proceed to

CAN DTC is not output

A

CAN DTC is output

B

B

GO TO CAN COMMUNICATION SYSTEM


A

4.

PROBLEM SYMPTOMS TABLE

(a) Refer to the Problem Symptoms Table (See page ).


Result

Proceed to

Fault is not listed in problem symptoms table

A

Fault is listed in problem symptoms table

B

B

GO TO STEP 6


A

5.

OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check (See page ).


(b) Terminals of ECU (See page ).


(c) Data List / Active Test (See page ).



NEXT

6.

REPAIR OR REPLACE

NEXT

7.

CONFIRMATION TEST

NEXT

END
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main body ECU (Multiplex network body ECU) Combination meter a ...

System Description
SYSTEM DESCRIPTION 1. KEY REMINDER WARNING SYSTEM DESCRIPTION (a) When the driver side door is opened while the ignition switch is ACC or off and the key is in the ignition key cylinder, this syst ...

Other materials about Toyota 4Runner:

Inside Handle Illumination Light Circuit
DESCRIPTION The main body ECU (multiplex network body ECU) controls the inside handle illumination. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedu ...

Health Check
HEALTH CHECK 1. HEALTH CHECK Health Check provides an overall view of the vehicle status including telematics. Health Check will provide the DCM (Telematics Transceiver) software version, PRL version, and applicable DTCs and fault codes related to telema ...

© 2016-2026 | www.to4runner.net

0.0066