Toyota 4Runner: Inside rear view mirror
Glare from the headlights of vehicles behind can be reduced by using the following functions:
Manual anti-glare inside rear view mirror
1. Normal position
2. Anti-glare position
Auto anti-glare inside rear view mirror
In automatic mode, sensors are used to detect the headlights of vehicles behind and the reflected light is automatically reduced.
Turns automatic mode on/off
The indicator comes on when automatic mode is turned on.
Vehicles without a smart key system
The mirror will revert to the automatic mode each time the engine switch is turned to the “ON” position.
Vehicles with a smart key system
The mirror will revert to the automatic mode each time the “ENGINE START STOP” switch is turned to IGNITION ON mode.
Adjusting the height of rear view mirror
Adjust the height of the rear view mirror by moving it up and down.
To prevent sensor error (vehicles with auto anti-glare inside rear view mirror)
To ensure that the sensors operate properly, do not touch or cover them.
CAUTION
Caution while driving
Do not adjust the position of the mirror while driving.
Doing so may lead to mishandling of the vehicle and cause an accident, resulting in death or serious injury.
Steering wheel
The steering wheel can be adjusted to a comfortable position.
Hold the steering wheel and push the lever down.
Adjust to the ideal position by moving the steering wheel horizontally and
vertic ...
Outside rear view mirrors
Mirror angle can be adjusted using the switch.
To select a mirror to adjust, press the switch.
1. Left
2. Right
To adjust the mirror, press the switch.
1. Up
2. Right
3. Down
4. Left
...
Other materials about Toyota 4Runner:
XM Tuner Malfunction (B15BA)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the stereo component tuner
assembly.
DTC Code
DTC Detection Condition
Trouble Area
B15BA
When either of the conditions below is met: ...
Air Conditioning Control Panel Circuit
DESCRIPTION
This circuit consists of the heater control assembly and air conditioning amplifier
assembly. When the heater control assembly is operated, signals are transmitted
to the air conditioning amplifier assembly through the LIN communication system ...
0.0255