INSTALLATION
PROCEDURE
1. INSTALL STEERING WHEEL ASSEMBLY
(a) Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
(b) Install the steering wheel assembly set nut.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
2. INSTALL CRUISE CONTROL MAIN SWITCH
3. INSTALL STEERING PAD SWITCH ASSEMBLY
(a) Attach the 2 claws and 4 guides to install the steering pad switch assembly.
(b) Install the 4 screws.
Torque:
2.4 N·m {24 kgf·cm, 21 in·lbf}
(c) Connect the connector.
4. INSTALL STEERING PAD
5. INSTALL NO. 2 STEERING WHEEL LOWER COVER
6. INSTALL NO. 3 STEERING WHEEL LOWER COVER
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page
).
8. CHECK SRS WARNING LIGHT
(See page
)
InspectionInstallation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL REAR AIRBAG SENSOR LH
(a) Turn the ignition switch off.
(b) Disconnect the c ...
Accumulator Solenoid Malfunction / Upside (C1831/31,C1832/32)
DESCRIPTION
The stabilizer control ECU receives information from the steering angle sensor,
skid control ECU (speed signal) and yaw rate and acceleration sensor via CAN communication.
Based on this information, the stabilizer control ECU turns the stabili ...