Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rear Door Window Frame Moulding / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard:

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)
Window Frame Moulding	20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body or window frame moulding excessively.

PROCEDURE

1. INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING LH

(a) Clean the vehicle body surface.

(1) Using a heat light, heat the vehicle body surface.

(2) Remove the double-sided tape from the vehicle body surface.

(3) Wipe off any tape adhesive residue with cleaner.

(b) Install a new rear door front window frame moulding.

(1) Using a heat light, heat a new rear door front window frame moulding and the vehicle body surface.

(2) Remove the peeling paper from the face of the rear door front window frame moulding.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.

(3) Attach the clip and double-sided tape to install the rear door front window frame moulding.

HINT:

Press the rear door front window frame moulding firmly to install it.

2. INSTALL REAR DOOR WEATHERSTRIP LH

(a) Attach the 3 clips to install the upper part of the rear door weatherstrip.

3. INSTALL REAR DOOR BELT MOULDING LH

4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

5. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

7. INSTALL REAR DOOR GLASS RUN LH

8. INSTALL REAR DOOR SERVICE HOLE COVER LH

9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

11. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

13. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. When removing the window frame moulding, heat th ...

Other materials about Toyota 4Runner:

Display does not Dim when Light Control Switch is Turned ON
PROCEDURE 1. CHECK IMAGE QUALITY SETTING (a) Turn the light control switch to the tail or head position. (b) Check that the daytime screen setting on the display adjustment screen is set to on. Result ...

Ambient Temperature Sensor Circuit (B1412)
DESCRIPTION The cooler thermistor (ambient temperature sensor) is installed in the front part of the cooler condenser assembly. This sensor is connected to the air conditioning amplifier assembly and detects fluctuations in the ambient temperature. The se ...

Toyota 4Runner: Installation

Removal

Rear Spoiler

Other materials about Toyota 4Runner: