Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Front Door Lock / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

3. INSTALL FRONT DOOR LOCK ASSEMBLY LH

NOTICE:

When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water to enter into the connection. This may result in a malfunction of the front door lock assembly.

(a) Apply MP grease to the sliding parts of the front door lock assembly.

(b) Install a new door lock wiring harness seal to the front door lock assembly.

(d) Check that the front door lock open rod is securely connected to the front door lock assembly.

(e) Using a T30 "TORX" wrench, install the front door lock assembly with the 3 screws.

Torque:

5.0 N·m {51 kgf·cm, 44 in·lbf}

(f) Connect the connector.

4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH

5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

6. INSTALL FRONT DOOR GLASS RUN LH

7. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

8. INSTALL FRONT DOOR SERVICE HOLE COVER LH

9. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

10. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

11. INSTALL DOOR NO. 2 INSIDE HANDLE BEZEL LH

12. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

14. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT DOOR LOCK ASSEMBLY LH (a) Check the door lock motor operation. (1) Apply battery voltage to the motor connector and check the operation of the door lock. ...

Other materials about Toyota 4Runner:

Automatic transmission
Select a shift position appropriate for the driving conditions. Shifting the shift lever Vehicles without a smart key system: While the engine switch is in the “ON” position, move the shift lever with the brake pedal depressed. Vehicles with a s ...

System Diagram
SYSTEM DIAGRAM Communication Table Transmitter Receiver Signal Communication Line Air conditioning amplifier assembly ECM A/C idle up request signal CAN ...

Toyota 4Runner: Installation

Inspection

Key Reminder Warning System

Other materials about Toyota 4Runner: