Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Interior / Heating / Air Conditioning / Front Evaporator Temperature Sensor / Installation

INSTALLATION

PROCEDURE

1. INSTALL AIR CONDITIONING UNIT

(a) Install the air conditioning unit (See page ).

Inspection

INSPECTION PROCEDURE 1. INSPECT NO. 1 COOLER THERMISTOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Conne ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR NOTICE: If reusing the evaporator, do not insert the sensor into a location where the sensor was previously inserted. (a) Insert the se ...

Other materials about Toyota 4Runner:

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are output by the blinking of the tire pressure warning light. WIRING DIAGRAM HINT: When each warning light blinks continuously, a ground short in the w ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR AXLE SHAFT RH (a) Remove the rear axle shaft RH (See page ). 2. REMOVE REAR AXLE SHAFT LH HINT: Use the same procedure described for the RH side. 3. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft asse ...